Discussion Category:  All Categories

Typhoon Trio+ errors

Hello, I am trying to repair a GE Typhoon Trio +. I was able to scan with the Green laser, but when I tried the Blue laser I got the error: 0x130d Blue Laser Power Low, I replaced the Laser and control board. After I did that, I only get the error: 0x1100 Fast Stage Stroke Error while trying to initialize or move. After banging my head against the machine for a while I reinstalled the old laser and control board to see if that was the issue, i still receieved error 0x1100, and could not get it to scan at all. I could really use some help on this, Thanks

avatar placemark

Asked by

FixerOfThings
Report this Post
avatar placemarkReply by
soren.nielsen5253

I think to clean long lead screw and then add a good molybdenium grease

Report this Post
avatar placemarkReply by
jb17257180
Hi @FixerOfThings, did you manage to resolve this error? We are having the same issue with our Typhoon 8610.
Report this Post
avatar placemarkReply by
FixerOfThings
Unfortunately not, we ended up scrapping the entire unit. I spent a few weeks trying to repair it but was unable to get it working.
Report this Post

Page 1 of 1