Discussion Category:  Atomic Absorption

Problem with autosampler AS800- please help

Error Message: Furnace autosampler has timed out. The furnace autosampler was unable to cycle normally and is now in standby mode

 

During a stability check, the calibration, blanks, and LFB came out fine and then we were prompted with this error message.

The autosampler tray is now not moving during a run and therefore the sampling arm is improperly placed. The tray is rotating fine but does not move left and right. During the rinse phase, the tip is injecting into a sample cup.

 

Thank you for your help

avatar placemark

Asked by

Becky W
Report this Post

Page 1 of 1