Discussion Category:  Centrifuge

T2 Temp problem

Hi,

I am trying to fix a problem I encountered while using Avanti J# centrifugre. It is now showing T2, TEMP...Call service.

I have tried:

1. turning on/off machine

2. [ENTER]411 [CE] 

It still does not work.

I am not sure what to do.

The problem was that I had two runs on the machine. First was for 6000g and next one was for 20000g for 30 mins. First run was fine but while during second run the machine stopped running and spped came to zero and I got a message 45 minutes door locks,..44 min 43 min..and so on. I finally poened the door and removed the sample.

Regards,

prats1988

avatar placemark

Asked by

prats1988
Report this Post

Page 1 of 1