Agilent Technologies - 3100 OFFGEL Fractionator
Protein fractionation, in-solution recovery
Active Questions & AnswersAsk a Question
There are no current Discussions
Need Equipment Support?
Documents & ManualsView All Documents
Features of 3100 OFFGEL Fractionator
- pI-based OFFGEL fractionation with 0.1 – 0.6 pH resolution depending on consumable kit used
- In-solution fraction recovery for easy transfer to LC/MS
- Two power supplies allow simultaneous fractionation of two sample sets with broad differences in concentration
- Up to 16 samples fractionated at the same time
- µg to mg load capacity
- Possible to run conventional in-gel IEF as well as OFFGEL fractionation
- Preconfigured methods for OFFGEL and in-gel modes
- Online current control for each individual sample
- Simple, reproducible, and easy to use
General Specifications
Depth | 16.8 in |
Height | 6.2 in |
Width | 14 in |
Power Requirements | 100-240 VAC, 50/60 Hz, 140 VA |
Weight | 31 lbs |
Additional Specifications
Temperature Range: -40 to 70°C Ambient non-operating
Humidity: < 80% at 40° C (104 °F) Non-condensing
Operating altitude: Up to 2000 m (6500 ft)
Non-operating altitude: Up to 4600 m (14950 ft)
Safety standards IEC, CSA, UL: Installation Category II, Pollution Degree 2
Platform temperature:
Range: 10 - 35 °C
Max. 10 °C below ambient
Non condensing
Power supplies:
2 independent high voltage power supplies
Voltage range: 0.5–10kV
Current range: 0-150 uA/ strip
Power: 0-1 W/strip
Modes:
Constant voltage
Constant current
Contant power
Timetable programable
(Individual current control for each sample)
Fractionation capacity: 2 x 8 samples (12 or 24 fractions) in OFFGEL mode and IPG-IEF (in gel) on 2 individual trays
Resolution: 0.1 - 0.6 pH units between neighboring fractions, depending on kit used
Loading capacity: 50 µg – 5 mg of total protein or peptide amount per sample
Content: Each kit contains all chemical and consumables for 12 OFFGEL fractionations