LECO Corporation - AF700
Monitors ash cone deformation temperatures in coal ash, coke ash, and mold powders via ash fusion.
Active Questions & AnswersAsk a Question
Recent Questions & Answers
Elemental Analyzers Service ProvidersView All (6)
Documents & ManualsView All Documents
Features of AF700
- Exclusive Eclipse architecture—a unique design by LECO that improves reliability and serviceability
- A stable, permanently mounted integrated camera—isolated from the high temperature area
- Integrated viewing system—consistently aligns mirrors with camera and furnace
- LED light ring—enables accurate low temperature deformation point measurement
- High-endurance six-element heating furnace—six 3/4 inch (1.9 cm) heating elements have strength and power load capacity resulting in a durable long-life furnace that requires less maintenance
General Specifications
There are no General Specifications available.
Additional Specifications
Temperature Range 400°C to1500°C (750°F to 2730°F)
Temperature Ramp Rate Programmable from 4°C to 12°C/minute
Temperature Display °C, °F, or °K
Maximum Sample Load6 samples per analysis
Conforms to MethodsASTM, DIN, ISO, BSI
Ash Fusibility Determination Automatic or manual (IT, ST, HT, FT)
Analysis Time 4 hours typical cycle time (depending on ramp rate and temperature range)
Image Collection Digital (up to 30 frames/minute)
Image Resolution 1280 x 1024 pixels
VentilationBuilt-in 160 CFM/furnace
Exhaust 4 inch diameter (10.2 cm) active exhaust hose capable of handling
160 CFM flow, with no back pressure
Safety Built in CO monitor with auditory alarm, gas flow stopped on alarm
Physical Dimensions38 in. H x 13 in. W x 32 in. D (97 x 33 x 81 cm)
Shipping Weight 170 lb. (77 kg)
Electrical Requirements 215 to 253 V~ (at max load), 50/60 Hz, single phase, 30 A, 23,600 BTU/hr
Environmental Conditions 15°C to 35°C (59°F to 95°F)